Carl's Grill Talk

This is a Regal04ALP that I found with a customer in Lonoke, Arkansas. It is a Grand Hall made grill, and the factory has ceased to carry some of the parts like the heat shields and burner brackets.

 
Img 2092 - Shows the spec plate with the model number and serial number.

Img 2089 - The cooking grids lift out showing the ceramic heat plates. You can lift them out with the bracket holding them.

Img 2088 - The burners have a cotter pin in the back holding them to the burner bracket. The burner bracket is held by a bolt on each side.

Img 2133 - The upper heat shield located under the burners bolted to the grill bottom with 4 bolts. It is 2 pieces with the top one bolted to the lower one.

Img 2134 - The 2 upper heat shield pieces separated.

Img 2087 - The grill with the 2 upper heat shield pieces removed.

Img 2090 - The grill with CLA-MS0076 installed. The grill will perform without the upper part installed.

Img 2129 - This is the original grease tray along with the lower heat shield. The grease tray slides in from the grill front.

Img 2136 - This picture shows the replacement CLA-DS0075 with CLA-MS0077 lower heat shield sitting on it. It can but doesn't need to be bolted to the grease tray. The CLA lower heat shield will have to be slightly altered tp sit flat on the grease tray.

Img 2137 – Replacement part CLA-MS0077 lower heat tray

The electrodes are held to the grill wall and have an inner wall to go through.  See all the CLA parts at this link:  http://www.clagrills.com/allgrillparts/members_mark/members_mark-model-regal04alp.htm